Microbelts are manufacturers and exporters of Poly Belts, Cogged Fan Belts, Industrial Vee Belts, Reinforced Flap Patches for Tyre Industry

INDUSTRIAL VEE BELTS: SECTIONS & SIZES

TECHNICAL GUIDELINE

Nominal Inside Length in mm	Nominal Inside Length in inches	Number of Consecutive Grading Numbers any of which may be Used to make match set
1930 to 2515	76 to 99	4 Nos.
2540 to 4089	100 to 161	5 Nos.
4115 to 7544	162 to 297	6 Nos.
7569 to 9830	298 to 387	7 Nos.
9855 & above	388 & above	8 Nos.

SELECTION OF TYPE OF MICRO VEE BELT SECTION
Selection of the most favourable VEE-Belt section can be Facilitated by the use of the adjacent Figure (A). In border line cases, alternative design calculations may be necessary to determine the best solution to a drive problem.

MATCHING OF MICRO VEE BELTS

MICRO Matched Sets
(Confirming to IS : 2494 - Latest)

The belts running on a multiple VEE-Belts drive should be in matched set in order to avoid uneven distribution of load. It is recommended that the belts having same grading number should be used on a particular drive It is also recommended that users should not mix belts of different Makes on one drive. Use only MICRO VEE BELTS.